Source-audio Hot Hand 3 Universal Wireless Adapter User Manual download pdf (Page 14)

14 | Status LEDs and troubleshooting

LED State Description

Ring LED — fast blink Ring is being charged.

Ring LED — slow blink Ring is trying to ﬁnd a receiver to link up with. Make

sure that the receiver is plugged into the correct port

and is powered up properly. If it still doesn’t work,

cycle the power.

Ring LED — off Ring is off or the battery charge is complete. Press

the ring ON/OFF switch to turn the ring on. If the ring

does not turn on, check the directions for charging

the battery above.

Ring LED — solid [no blink] Ring is on and is communicating with the receiver.

Receiver [status] LED — Receiver is looking for a ring. Turn on the ring to

slow blink complete the link.

Receiver [status] LED — Temporary loss of signal from ring. Once the ring and

intermittent blink receiver are properly linked, the STATUS LED will

indicate that the signal from the ring is being properly

received. If the ring signal goes out of range, is

blocked, or if there is interference on the channel, the

STATUS LED will turn off temporarily to indicate that

the ring signal has been lost. Bring the ring back in

range or cycle the power to ﬁnd a new channel.

Receiver [status] LED — off If the STATUS LED is off, the receiver is not being

powered. Make sure that the DC adaptor is plugged

into the receiver unit or that the sensor cable is con-

nected to a Soundblox pedal.

1 2 ... 9 10 11 12 13 14 15 16

No comments

Source-audio Hot Hand 3 Universal Wireless Adapter User Manual Page 14