Source-audio Hot Hand Phaser/Flanger User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 19
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
KNOCK control (Effect=Envelope)
This parameter enables the unit to be toggled between effect on and effect
off by tapping the sensor wearing hand against a hard surface, such as the
guitar. There is a threshold level, which may be adjusted as needed. Higher
thresholds will need a harder tap to be recognized, but there will be less
chance of an accidental trigger from normal hand motions. Somewhere in
the middle of the range will generally be best. Note that this control may be
used regardless of whether or not the Hot Hand is being used as a modula
-
tion source.
DEPTH
Knob Threshold
0 KNOCK is disabled (default setting)
1 Lowest threshold (easiest)
2
3
4
5
6
7
8 Highest threshold (hardest)
Sequencer Controls | 3130 | Back Page Features and Controls
Sequencer Controls
There are 9 patterns available for each of 9 length selections. The first length
selection is for a length of 3. It also includes the only possible length 2 pat
-
tern, a square wave. Since there aren’t enough other length 3 patterns to fill
out the entire list of 9 patterns, several length 6 patterns are also included.
The other lengths, from 4 through 12 (excluding 11) are all consistent through
each of their patterns. A brief description of the nature of the patterns is in
the table below. For lengths 9, 10, and 12, the narrow pulse pattern (all steps
at the lowest level, except for one at the highest) seemed pointless, and so a
more complicated pattern was used.
Sequence/Random (Effect=Flanger 01)
This parameter determines whether the sequencer will cycle through the
pre-stored sequence patterns, or use random values that don’t repeat. If
random is selected, the pattern and length parameters are ignored.
Piggy-backing on this parameter is the ability to speed up the LFO by a factor
of 100. This speed up applies even if the sequencer is not selected.
DEPTH
Knob Seq/Ran
0 Use sequence patterns (default setting)
1 Use random levels
2 Use sequence patterns; LFO speed is 100 times faster than normal
3 Use random levels; LFO speed is 100 times faster than normal
Pattern (Effect=Flanger 03)
The sequence pattern selection.
DEPTH
Knob Pattern description
0 triangle
1 rising saw
2 falling saw
3 narrow pulse (lengths of 9, 10, and 12 have other complex patterns)
4 only 3 different levels present in the pattern
5 only 2 different levels present in the pattern
6 complex patterns (default setting)
7 complex patterns
8 complex patterns
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments