Source-audio Soundblox 2 Stingray Multi-Filter User Manual download pdf (Page 15)

Controls: Footswitches

| 15

1 2

CONTROL

INPUT

OPTION

SELECT

ENV-ENV+

DEPTH

OPTION

SPEED

DELAY/FREQ

FEEDBACK

VOLUME

TREMOLO

MIX

(HOLD)

DEFAULT

MIDI

EXP

FLANGER

CHORUS

PHASER

RESONATOR

MOD SOURCE

4 STAGE

QUAD

CLASSIC

THRU

ZERO

SHADOW

RES 1

RES 2

VIBE

6 STAGE

8 STAGEDUAL

12 STAGE

O RB ITAL

MODU L A T OR

A B

TAP TEMPO MODE

The STINGRAY’s LFO rate can also be adjusted “on-the-fly” via TAP TEMPO.

To enter TAP TEMPO mode, put the pedal into bypass, then press and hold the

footswitch (A or B), to which you would like TAP TEMPO applied. When the

preset LED opposite the footswitch being held starts to blink, the pedal is in

TAP TEMPO mode. The footswitch below the blinking LED now controls the

LFO rate. Press the footswitch at least two times in rhythm to set a new LFO

rate. The LFO rate is reflected in the blinking LED – the time between each

blink represents one cycle of the LFO. Follow the same procedure to

disengage TAP TEMPO. The footswitch that TAP TEMPO is applied to, is also

the preset it is saved to. When recalled, the speed of the TAP TEMPO will

default to the last used setting.

14 | Controls: Footswitches

CONTROLS: FOOTSWITCHES

There are two footswitches on the STINGRAY. The left footswitch

corresponds to preset 1, and the right footswitch corresponds to preset

2. Pressing either of the footswitches will engages the respective

preset. Pressing the same footswitch again puts the pedal back into

bypass mode. Pressing the other footswitch engages the other preset

without going into bypass. The illumination of the LEDs labeled “1” and

“2” indicates which preset is currently enabled. While the pedal is in

bypass mode both LEDs remain off.

When a preset is enabled and any sort of adjustment is made, the

indicator LED for that preset will begin to blink, showing that the preset

has been edited. After a preset has been edited, save it by pressing and

holding either footswitch. The corresponding LED will blink quickly to

indicate that the preset has been saved. Once changes are saved, the

LED will be lit solidly (not blinking).

An edi

ted preset can be saved to

either of the two preset locations. For example, if preset 1 has been

selected and edited, it can be saved to preset location 2 by pressing and

holding the right footswitch.

Note: Changes made to a preset will be lost if you go into bypass or

switch to another preset without saving.

Stingray Manual - pages 14, 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comments to this Manuals

No comments

Source-audio Soundblox 2 Stingray Multi-Filter User Manual Page 15

Comments to this Manuals

Related products and manuals for Audio Source-audio Soundblox 2 Stingray Multi-Filter