Source-audio Soundblox Pro Bass Envelope Filter User Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
17
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
18
19
21
20
01
EQ ONLY
2 POLE LOW PASS
4 POLE LOW PASS SINGLE PEAK
TRIPLE PEAK
PEAK & NOTCH
PHASERS
62 125 250 500 1K
(XD) (XC) (OE) (VA) (Q) (EL) (LS)
2K 4K
+12
-12
0
< >
MOD
SOURCE
TAP TEMPO
ENABLE
PRESET BANK
4-61-3
(HOLD)
CALIBRATE
BACKPAGE
MODE
ENVELOPE
LFO
HOT HAND
USER
00
22
SWEEP RANGE SPEED
FREQUENCY MIX
FAST FAST
SLOW SLOW
WET
DRY
WET
DECAY
X-AXIS
ATTACK
& DECAY
Y-AXIS
HOT
HAND
LFO
MINMIN
DOWN UP
MAX MAX
BASS ENVELOPE FILTER
14
25
3
(TAP TEMPO)
6
12 | Controls: Footswitches
CONTROLS: FOOTSWITCHES
There are three footswitches on the BEF Pro. From left to right, the
footswitches correspond to presets
1, 2, and 3 for preset bank A and 4, 5,
and
6 for bank B. Pressing any of the buttons will engage a given preset.
Pressing the footswitch for the currently engaged effect will put the unit
into bypass mode. Pressing another switch will engage the correspond-
ing preset without going into bypass.
The indicator lights above the three footswitches are bi-color and will
change depending on which bank is selected. Bank
A presets are green
while bank
B presets are red. When a preset is edited, the LED will begin
to blink, indicating that the preset has been changed. When a preset
has been edited, pressing and holding any of the switches will save
the changes to the corresponding preset. The
LED will blink quickly to
indicate that the preset has been saved. Once changes are saved, the
LED will be lit solidly. See the “Preset Saving” section for other saving
options.
Note: Changes made to a preset will be lost if you go into bypass or
switch to another preset without saving.
Tap Tempo
In Tap Tempo Mode, the rightmost footswitch can be used to change the
speed of the
LFO. Tap the footswitch at least two times in rhythm to set a
new
LFO speed. The tapped speed will be one cycle of the LFO. The new
speed will also be reflected in the blinking
LED above the footswitch.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comments to this Manuals

No comments