Source-audio Soundblox 2 Dimension Reverb User Manual download pdf (Page 15)

Controls: Footswitches | 15

CONTROLS: FOOTSWITCHES

There are two footswitches on the Dimension Reverb. The left footswitch

corresponds to preset 1 and the right footswitch corresponds to preset

2. Pressing either of the footswitches will engage the respective preset.

Pressing the same footswitch again will put the effect back into bypass

mode. Pressing the other footswitch will engage the other preset without

going into bypass. There are indicator LEDs for each footswitch that show

which preset is currently enabled or both LEDs will be off when the effect

is in bypass mode.

When a preset is enabled and edited, the indicator LED for that preset will

begin to blink occasionally to show that the preset has been edited. Once

a preset has been edited, it can be saved by pressing and holding the

footswitch. The LED will blink quickly to indicate that the preset has been

saved. Once changes are saved, the LED will be lit solidly again.

Note: Changes made to a preset will be lost if you go into bypass or

switch to another preset without saving.

An edited preset can be saved to either of the two preset locations. For

example if preset 1 has been selected and edited, it can be saved to pre-

set location 2 by pressing and holding the right footswitch.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

No comments

Source-audio Soundblox 2 Dimension Reverb User Manual Page 15