Source-audio Soundblox 2 OFD Guitar microModeler User Manual download pdf (Page 12)

12 | Controls: Footswitches

CONTROLS: FOOTSWITCHES

There are two footswitches on the OFD. The left footswitch corresponds

to preset 1 and the right footswitch corresponds to preset 2. Pressing

either of the footswitches will engage its respective preset. Pressing the

engaged footswitch will put the effect back into bypass mode and press-

ing the unengaged footswitch will change to the other preset without

going into bypass. The illumination of the LEDs labeled “1” and “2” indi-

cate which preset is currently enabled. While the effect is in bypass mode

both LEDs remain off.

When a preset is enabled and any sort of adjustment is made, the

indicator LED for that preset will begin to blink, showing that the preset

has been edited. After a preset has been edited, save it by pressing and

holding either footswitch. The corresponding LED will blink quickly to

indicate that the preset has been saved. Once changes are saved, the LED

will illuminate continuously. An edited preset can be saved to either of

the two preset locations. For example if preset 1 has been selected and

edited, it can be saved to preset location 2 by pressing and holding the

right footswitch.

Note: Changes made to a preset will be lost if you go into bypass or

switch to another preset without saving.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

No comments

Source-audio Soundblox 2 OFD Guitar microModeler User Manual Page 12