Source-audio Soundblox Pro Multiwave Bass Distortion Pro User Manual download pdf (Page 6)

Controls: Equalizer | 1110 | Controls: Knobs

CONTROLS: EQUALIZER

One of the key features of the MWB Pro is the 7-band graphic equalizer.

The Equalizer is post distortion. Each band can be adjusted up or down

1 dB steps from -12 dB to +12 dB and the setting is indicated by the dis-

play. The display shows

1 dB steps by lighting adjacent LEDs with varying

brightness. The equalizer section has three controls:

BAND SELECT LEFT and RIGHT

The two buttons on either side of the

EQ knob select the frequency band

to edit.

EQ KNOB

The equalizer knob changes the value of the selected band up or down in

1 dB steps.

You can quickly and easily zero the equalizer by pressing both left and

right band select buttons at the same time. The equalizer display will

reset to a default “at” setting.

DRIVE

The

DRIVE control adjusts the gain of the signal going into the distortion

section. The higher the

DRIVE, the more distorted the signal.

CLEAN MIX

The

CLEAN MIX knob controls the amount of dry, unaffected signal going

to the output. The clean signal used in this control does

NOT have any EQ

applied. This control is especially useful for getting back some of the low

end frequencies that can be lost in the pure distorted signal.

DISTORTION MIX

This adjusts the overall level of the distorted signal. Along with the

CLEAN MIX knob, it can be used to balance the levels of clean vs. distor-

tion. Also, the overall output level can be increased by turning up both

clean and distortion mix levels.

DRIVE

CLEAN MIX

DISTORTION MIX

62 125 250 500 1K 2K 4K

+12

-12

< >

+12

-12

(NG) (HG) (HS) (HA) (HR)

EQKnob

BandSelectRightBandSelectLeft

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Source-audio Soundblox Pro Multiwave Bass Distortion Pro User Manual Page 6

Comments to this Manuals

Related products and manuals for Audio Source-audio Soundblox Pro Multiwave Bass Distortion Pro