Source-audio Soundblox Pro Classic Distortion Pro User Manual download pdf (Page 7)

Controls: Footswitches | 1312 | Controls: Other Buttons

CONTROLS: FOOTSWITCHES

There are three footswitches on the Classic Pro. From left to right, the

footswitches correspond to presets

1, 2, and 3 for preset bank A and 4, 5,

and

6 for bank B. Pressing any of the buttons will engage a given preset.

Pressing the footswitch for the currently engaged effect will put the unit

into bypass mode. Pressing another switch will engage that effect with-

out going into bypass.

The indicator lights above the three footswitches are bi-color and will

change depending on which bank is selected. Bank A presets are green

while bank B presets are red. When a preset is edited, the

LED will begin

to blink occasionally to show that the preset has been changed. When a

preset has been edited, pressing and holding any of the switches will save

the changes to the corresponding preset. The

LED will blink quickly to

indicate that the preset has been saved. Once changes are saved, the

LED

will be lit solidly. See the Preset Saving section for other saving options.

Note:Changes made to a preset will be lost if you go into bypass or

switch to another preset without saving!

CONTROLS: OTHER BUTTONS

PRESET BANK

There are six available user presets that are in two banks. The bank can

be switched by pressing the

PRESET BANK button. When preset bank A is

selected, pressing the corresponding footswitches will select presets

2, or 3. When preset bank B is selected, the footswitches select presets

4, 5, and 6. The indicator lights (LEDs) above each footswitch will be green

for bank A and red for bank B.

HH ENABLE

The Hot Hand enable button enables or disables Hot Hand control for the

selected preset. This way, Hot Hand control can be set up for an individual

preset and can be left off otherwise.

CALIBRATE

Pressing this button when the pedal is engaged will turn on calibration

mode. Calibration mode allows you set a zero point for an attached Hot

Hand sensor. Calibration can only be enabled when

HH ENABLE is on.

HH ENABLE

CALIBRATE

BACKPAGE

MODE

125 250 500 1K 2K

(NG) (HG) (HS) (HA) (HR)

4K 8K

+12

-12

< >

+12

-12

DRIVE 1 MIDRANGE

CLEAN BOOST / EQ

DRIVE 2 OUTPUT

HH ENABLE

CALIBRATEPRESET BANK

4-61-3

BACKPAGE

MODE

BENDER

SMOOTH TUBE

POWER STAGE

CRUNCH TUBE

TS9000

BIG PI

EL RATON

FUZZ FAÇADE

METAL

OCTAVE FUZZTUBE DRIVE

CLASSIC DISTORTION

PRESET BANK

4-61-3

BankBBankA

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Source-audio Soundblox Pro Classic Distortion Pro User Manual Page 7

Comments to this Manuals

Related products and manuals for Audio Source-audio Soundblox Pro Classic Distortion Pro