Source-audio Soundblox 2 Multiwave Bass Distortion User Manual download pdf (Page 13)

Controls: Footswitches | 13

CONTROLS: FOOTSWITCHES

There are two footswitches on the Soundblox 2 Multiwave Bass Distortion.

The left footswitch corresponds to preset 1 and the right footswitch cor-

responds to preset 2. Pressing either of the footswitches will engage the

respective preset. Pressing the same footswitch again will put the effect

back into bypass mode. Pressing the other footswitch will engage the

other preset without going into bypass. There are indicator LEDs for each

footswitch that show which preset is currently enabled or both LEDs will

be off when the effect is in bypass mode.

When a preset is enabled and edited, the indicator LED for that preset will

begin to blink occasionally to show that the preset has been edited. Once

a preset has been edited, it can be saved by pressing and holding the

footswitch. The LED will blink quickly to indicate that the preset has been

saved. Once changes are saved, the LED will be lit solidly again. See the

Preset Saving Details section for other saving options.

Note: Changes made to a preset will be lost if you go into bypass or

switch to another preset without saving.

An edited preset can be saved to either of the two preset locations. For

example if preset 1 has been selected and edited, it can be saved to pre-

set location 2 by pressing and holding the right footswitch.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

No comments

Source-audio Soundblox 2 Multiwave Bass Distortion User Manual Page 13