Source-audio Soundblox 2 Multiwave Bass Distortion User Manual download pdf (Page 20)

20 | Use with Hot Hand

USE WITH HOT HAND

All Soundblox pedals are compatible with our Hot Hand accessories. Hot

Hand units consist of a ring mounted accelerometer that is used to detect

motion for controlling effect parameters. On the Soundblox 2 Multiwave,

a Hot Hand unit can be connected to the Multi-Function input. To enable

Hot Hand, select the HH mode as the external control option. This will

take the input signals for the Hot Hand unit and use them to control either

the Morph or whichever parameter has been assigned.

The Soundblox 2 Multiwave Bass Distortion can also be calibrated to

change the midpoint of the Hot Hand control range. To do this, follow the

calibration procedure below. Note that Calibration is only used for Hot

Hand mode and calibration is NOT required before use.

To perform a calibration:

1. Select a preset by pressing a footswitch.

2. Enable Hot Hand control by selecting HH mode from the external

controls.

3. Press and hold the NOISE GATE button until the HH red LED begins

to blink slowly (this is the same as the control assign procedure).

4. Put the Hot Hand sensor into the desired calibration position.

5. Press the footswitch for the currently selected preset.

6. The HH LED will blink when the calibration is complete.

If you have trouble with calibration and need to get back to the default

setting, place the sensor on a ﬂat, level surface with the blue LED facing

down and run the calibration procedure again.

1 2 ... 15 16 17 18 19 20 21 22 23 24

No comments

Source-audio Soundblox 2 Multiwave Bass Distortion User Manual Page 20